If an alarm in an interconnection group alarms, the other alarms in the group will also alarm. Only alarms with the same ID can make up an interconnection group. The installing distance between any 2 alarms in an interconnection group should be within 150m.ĭIP Switch setup :For intended interconnected alarms, set their DIP switch to the same ID(16 groups in total. Loud 85 Decibel Piezo Electric Alarm Automatically resets when hazardous condition has passed. Test the sensitivity, circuitry, batteries, horn. Date Code: (located on back of alarm) The National Fire Protection Association (NFPA). The alarm will automatically reset after 10minutes. That the smoke alarm device has been silenced. The red light flashes every 10 seconds to remind you Silence your smoke alarm device by momentarily pressing the test button when non-emergency When battery for RF board is low: Alarm beeps and Green LED flashes every 53 seconds. When battery for mainboard is low: Alarm beeps and Red LED flashes every 53 seconds. Red LED flashes approximately every 53 seconds confirming unit is powered. Once it detects danger of fire smoke, red LED will flash rapidly and it will issue alarm sounds.īoth lifetime of battery for the mainboard and battery for the RF board can reach 10 years. It is capable of real-time detecting the presence of smoke. The smoke alarm part(mainboard part ) and RF board part are powered by two independent 3V battery separately. This situation changes with this wireless photoelectric smoke alarm. A smoke alarm that sounds alarm in the loft might not always be audible in the garage. In case of smoke emission in one of the protected rooms, all installed smoke alarms are activated. With the installation of more than one smoke detectors, the communication is wireless. This product is a smart photoelectric smoke alarm, which is combined with a RF transceiver.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |